| Ürüne ait diğer resimler |
1 |
2 |
3 |
|
|
EMX312SC EMX512SC
Maximum Output Power@ 0.5 % THD at 1 kHz 300 W/4 Ω190 W/8 Ω (UA)180 W/8 Ω (H) 500 W/4 Ω350 W/8 Ω (UA)320 W/8 Ω (H)
Frequency Response -3, 0, 1 dB20 Hz-20 kHz, ref to the nominal output level @ 1 kHz
Total Harmonic Distortion Less than 0.5 % (THD+N)+14 dB @ 20 Hz, 1 kHz, 20 kHz, GAIN control: all nominal
Hum & Noise*1 Equivalent Input Noise, -115 dBu, Rs = 150 Ω CH 1-4 MIC/LINE: MIC
Crosstalk @ 1 kHz -65 dB
Input Connectors CH 1-4: XLR and PhoneCH 5/6, 7/8: XLR and PhoneCH 9/10, 11/12: XLR and Pin
EQ HIGH, MID, LOW
Phantom Power 15 V
Graphic Equalizer 7 Band (125, 250, 500, 1 k, 2 k, 4 k, 8 kHz): Main (Stereo) and Monitor
Digital Effects SPX Digital Multi Effector (24 bit AD/DA, 32 bit Internal Processing): 16 Programs
Power Amp. Mode Main L/R, Main (L+R)/Monitor
Foot Switch Effect On/Off
Dimensions (W x D x H) 442 x 264 x 286 mm (17-3/8" x 10-3/4" x 11-1/4")
Weight 10 kg (22 lbs.)
Power Requirements/Consumption U/C: 120 V 60 Hz, 270 WH: 230 V 50 Hz, 270 WA: 240 V 50 Hz, 270 W U/C: 120 V 60 Hz, 400 WH: 230 V 50 Hz, 400 WA: 240 V 50 Hz, 400 W U/C: 120 V 60 Hz, 450 WH: 230 V 50 Hz, 450 WA: 240 V 50 Hz, 450 W
*1 Hum & Noise are measured with a 6 dB/octave filter @ 12.7 kHz; equivalent to a 20 kHz filter with infinite dB/octave attenuation.
Rack Mount Adaptor RK512All models in this series can be rack-mounted using an optional rack-mounting kit for optimum integration with any system or installation.
INPUT CHARACTERISTICS
Input Terminals MIC/LINE Actual Load Impedance For Use With Nominal Input level Connector
Sensitivity *2 Position Max. before clip
CH INPUT 1-4 XLR MIC 2 kΩ 50-600 Ω Mics -60 dBu(0.69 mV) -35 dBu(13.8 mV) -15 dBu(138 mV) XLR-3-31 type *3
LINE -30 dBu(21.8 mV) -5 dBu(436 mV) +15 dBu(4.36 V)
Phone MIC 6 KΩ 600 Ω -50 dBu(2.18 mV) -25 dBu(43.6 mV) -5 dBu(436 mV) Phone Jack *4
LINE -20 dBu(69.0 mV) +5 dBu(1.38 V) +25 dBu(13.8 V)
CH INPUT 5/6, 7/8 XLR - 2 kΩ 50-600 Ω Mics -60 dBu(0.69 mV) -35 dBu(13.8 mV) -15 dBu(138 mV) XLR-3-31 type *3
Phone - 10 KΩ 600 Ω Lines -20 dBu(69.0 mV) +5 dBu(1.38 V) +25 dBu(13.8 V) Phone Jack *5
CH INPUT 9/10, 11/12 XLR - 2 kΩ 50-600 Ω Mics -60 dBu(0.69 mV) -35 dBu(13.8 mV) -15 dBu(138 mV) XLR-3-31 type *3
Pin - 10 KΩ 600 Ω Lines -20 dBu(69.0 mV) +5 dBu(1.38 V) +25 dBu(13.8 V) RCA Pin Jack
*1 0 dBu is referenced to 0.775 Vrms.
*2 Sensitivity is the lowest level that will produce an output of +4 dB (1.23 V), or the nominal output level when the unit is set to maximum level. (All level controls are at maximum position.)
*3 XLR-3-31 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
*4 Phone Jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND)
*5 Phone Jacks are unbalanced.
Output Terminals Actual Source Impedance For Use With Nominal Output level Connector
Nominal Max. before clip
SPEAKER OUT[A1, A2, B1, B2] 0.1 Ω 4 Ω Speakers EMX512SC 125 W 500 W [A1, B1] SPEAKON
EMX312SC 75 W 300 W [A2, B2] Phone Jack *2
EMX212S 50 W 200 W
MAIN OUT [L, R] 600 Ω 10 kΩ Lines - +4 dBu (1.23 V) +20 dBu (7.75 V) Phone Jack *2
EFFECT OUT 600 Ω 10 kΩ Lines - +4 dBu (1.23 V) +20 dBu (7.75 V) Phone Jack *2
MONITOR OUT 600 Ω 10 kΩ Lines - +4 dBu (1.23 V) +20 dBu (7.75 V) Phone Jack *2
REC OUT [L, R] 600 Ω 10 kΩ Lines - -10 dBV (316 mV) +10 dBV (3.16 V) RCA Pin Jack
*1 0 dBu is referenced to 0.775 Vrms. 0 dBV is referenced to 1 Vrms.
*2 Phone Jacks are unbalanced.
|
